Table of Contents
Advertisement
AP8082DN and AP8182DN
Hardware Installation and Maintenance Guide
l When fixing the sheet metal mounting bracket, ensure that the arrows point upwards on the
l The length of the M6 inner hexagon screwdrivers must be greater than or equal to 200 mm.
l The adjustment range of the angle-adjustable mounting bracket for the AP8082DN is as follows:
l For details about how to install an enclosure, see
Installing an AP8082DN
1.
2.
3.
Issue 03 (2019-04-01)
NOTE
l
Without an enclosure: The adjustment range of the vertical angle is ±30°, and that of the horizontal
angle is ±40°.
l
With an enclosure: The adjustment range of the vertical angle is -20° to +30°, and that of the
horizontal angle is ±40°.
Fix the wall-side mounting bracket to the wall, adjust the installation position, and use
the marker to mark the drilling positions where expansion bolts are installed, as shown in
the following figure.
118 mm
Use an 8 mm drill bit to drill 35mm to 40 mm deep holes in the drilling positions and
hammer the expansion bolts into the installation holes until the flat washers are
completely attached to the wall. Then, remove the nut, spring washer, and flat washer in
order.
1
90
35 mm ~ 40 mm
3
Hang the wall-side mounting bracket on the expansion bolts and use a wrench to fasten
the flat washers, spring washers, and nuts in order.
Copyright © Huawei Technologies Co., Ltd.
2.5.3 Installing an Enclosure for an
2
Ø8
2 AP Installation
label.
AP.
18
Advertisement
Table of Contents
