Huawei AP8082DN Hardware Installation And Maintenance Manual page 54

AP8082DN and AP8182DN
Hardware Installation and Maintenance Guide
l
l
Tools and Accessories
l
l
l
l
Procedure
1.
2.
3.
Issue 03 (2019-04-01)
Cover unconnected optical modules with dust plugs.
Unplug the optical fibers from the optical module before removing it. Install or remove
optical fibers carefully to avoid damages to fiber connectors. Applying too much force to
the optical fibers may damage the optical module.
ESD wrist strap or ESD gloves
Dust caps
Dust plugs
Alcohol swab
Wear an ESD wrist strap or ESD gloves. Ensure that the ESD wrist strap is grounded and
in a close contact with your wrist.
Record the location of each optical fiber on the old optical module and check whether
the labels on the optical fibers are correct and clear. If any labels are unclear, replace
them and ensure that the details are correct.
Release the locking clip on the fiber connector, gently push the fiber connector inward,
and then pull out the optical fiber. After removing the optical fibers from the optical
module, cover the connectors with dust caps.
The locking clip varies on different fiber connectors.
– Figure 5-1 shows the locking clips on an LC/PC connector. Hold down the locking
clips when pulling the optical fibers.
Figure 5-2 shows the locking clip on an MPO connector. The locking clip is
–
released automatically when you pull the MPO connector.
Figure 5-3 shows the locking clip on an SC/PC connector. The locking clip is
–
released automatically when you pull the SC/PC connector.
Figure 5-1 LC/PC connector
Figure 5-2 MPO connector
Copyright © Huawei Technologies Co., Ltd.
5 Maintaining the Device
47