Huawei AP8082DN Hardware Installation And Maintenance Manual page 108

AP8082DN and AP8182DN
Hardware Installation and Maintenance Guide
Figure 6-91 Installing the heat-shrink tubing and the O-ring seal
Step 4 Put the back shell of the connector onto the feeder cable. Tighten the back shell to the end of
the feeder cable, as shown in
Figure 6-92 Putting the back shell of the connector onto the feeder cable
Step 5 Mount the body of the connector onto the feeder cable so that the inner conductors of the
connector and feeder cable are connected. Use a spanner (27 N•m to 30 N•m torque
recommended) to fasten the body and back shell, as shown in
Issue 03 (2019-04-01)
Figure 6-92.
Copyright © Huawei Technologies Co., Ltd.
6 Appendix
Figure 6-93.
101