Huawei AP8082DN Hardware Installation And Maintenance Manual page 153

AP8082DN and AP8182DN
Hardware Installation and Maintenance Guide
l
Merging Cells in the Template
To merge two or more cells, do as follows:
1.
2.
3.
Requirements on the Printer
To print labels, use a laser jet printer of any model. Before printing labels, set up the page and
try printing.
1.
2.
The method for adjusting the page setup is as follows.
1.
2.
3.
After the page setup has been made correctly, save it for future use. This page setup is only
necessary the first time you use the template to print the labels.
Issue 03 (2019-04-01)
If many characters need to be filled in, decrease the font size, but make sure that the
printouts are clear and legible.
Select Edit/Select All.
Select Format/Borders and Shading/Borders. Select Box tab and click OK.
Drag the mouse to select cells to be merged and select the Table/Merge Cells.
Try printing on ordinary paper with both sides blank. Place the blank paper over the
whole page of the label paper, and check whether the page setup conforms to the label
layout.
Make sure the printer properties, such as "paper size" and "direction", have been set
correctly.
– If the printout conforms to the sheet of labels, print the labels on the label paper.
– If the printout does not conform, adjust the page setup and try printing again until
the correct printout is produced.
Select File/Page Setup.
Select Layout and set Header and Footer as 0.
Select the Margins tab page. Select Left for Gutter Position and adjust the values of Top,
Bottom, Left, and Right.
NOTE
If the warning prompt as shown in
the printing.
Figure 6-155 Warning prompt before printing
Copyright © Huawei Technologies Co., Ltd.
Figure 6-155 appears before printing, click Ignore to continue
6 Appendix
146