Huawei AP8082DN Hardware Installation And Maintenance Manual page 156

AP8082DN and AP8182DN
Hardware Installation and Maintenance Guide
Power Cable Label
Remove the label from the backing page, and attach it to the identification plate on the cable
tie. The label should be attached to the rectangular flute on the identification plate, and
attached to only one side of the identification plate. The cable ties are bundled at 2 cm (0.79
in.) from the connectors, and other positions are allowed in special circumstances.
Cable ties should be bound on both ends of a cable. After the bundling, the finished
identification plate should be on top of the cable in horizontal cabling, or on the right side of
the cable in vertical cabling, as shown in
l
l
Figure 6-159 Binding the label for the power cable
The identification card is on the
top of the cable in horizontal
cabling.
Issue 03 (2019-04-01)
Figure 6-158 Label for signal cables
The identification card is to the right of the cable in vertical cabling.
The identification card is on the top of the cable in horizontal cabling. Make sure that the
label is facing out.
TO:
B03 -48V2
Cable
Copyright © Huawei Technologies Co., Ltd.
Figure 6-159. The details are as follows:
The identification card is to
the right of the cable in
vertical cabling.
6 Appendix
149