Table of Contents
Advertisement
AP8082DN and AP8182DN
Hardware Installation and Maintenance Guide
3.
4.
Installing an AP8182DN
1.
Issue 03 (2019-04-01)
NOTE
The AP is of the cyclinder shape. It is recommended that this step be performed in the package.
Remove the topmost screw from the wall-side mounting bracket, hang the AP-side
mounting bracket onto the topmost screw, and tighten the screw until the screw passes
through the hole of the horizontal scale plate (the screw should not be too tight).
Loosen the M6 screw in the vertical direction, adjust the horizontal and vertical angles of
the device using the scale plate, and tighten all screws.
Determine the AP installation position and attach the pole-side mounting bracket on the
pole using the hose clamp.
a.
Use an M6 inner hex torque screwdriver to loosen the screw on the hose clamp to
open it.
b.
Lead the hose clamp through the mounting bracket and secure the mounting bracket
to the pole.
Copyright © Huawei Technologies Co., Ltd.
M4
1.4 N•m
M8
12 N•m
2 AP Installation
M6
5 N•m
24
Advertisement
Table of Contents
