Huawei AP8082DN Hardware Installation And Maintenance Manual page 173

AP8082DN and AP8182DN
Hardware Installation and Maintenance Guide
Com
pone
nt
Signal
cable
Issue 03 (2019-04-01)
Applic
No. able Check Item
Scope
Routes of signal cables comply with the engineering design
1 General document. The signal cables are correctly connected to
facilitate maintenance and capacity expansion.
Radio ports of an AP are correctly connected to radio ports
2 General
A/B/C of antennas.
Signal cable connectors are correctly installed and securely
connected to the device. Wires of each signal cable are
3 General
securely cramped in the connectors and pass connectivity
tests.
Signal cables are orderly routed and not crossed, twisted, or
winded (cables can be crossed at 1 m out of the cabinet). The
4 General
bend radius of cables meets requirements, and the cables are
not excessively bent.
Signal cables are not damaged or broken and have no splices.
Sufficient cable length is reserved. The reserved cables are
5 General
twined and placed properly to facilitate subsequent
maintenance.
Indoor The optical, power, network, and feeder cables are bundled
6
AP using straps (one strap every 0.5 m) and securely fastened.
The signal cables shall be bundled at even intervals (about
1000 mm), not too tight or too loose. The cables shall be
Outdoor bundled properly with cable ties placed in neat order. Cut off
7
AP redundant cable ties and remove burrs from them to avoid
injuries. The cables shall be fixed using fasteners or ageing-
resistant outdoor metal binding straps.
Keep the signal cables away from heat sources and use heat
insulation materials to insulate the cables from the heat
8 General sources. Do not place signal cables on the air vents of the
cabinet to avoid affecting subrack heat dissipation or cable
lifetime.
Copyright © Huawei Technologies Co., Ltd.
6 Appendix
166