Huawei AP3010DN-AGN Hardware Installation And Maintenance Manual page 48

Huawei AP3x10xN&5x10xN&5x30xN&6x10xN&7x10xN
Hardware Installation and Maintenance Guide
Step 2 Put the heat-shrinkable (A) tubing onto the bare crimping terminal, as shown in
Figure 5-3 Putting the heat shrink tubing onto the bare crimping terminal
Step 3 Put the OT terminal B onto the exposed conductor, and ensure that the OT terminal is in good
contact with the insulation coating C, as shown in
After the conductor is fed into the OT terminal, the protruding part of the conductor, or L2 in
Figure
Step 4 Crimp the joint parts of the bare crimping terminal and the conductor, as shown in
Issue 11 (2015-05-18)
NOTE
If you are proficient in assembling OT terminals and power cables, you can obtain the value of L1 by
comparing the part to be crimped with the power cable.
NOTICE
5-3, must not be longer than 2 mm (0.08 in.).
NOTE
The shapes of crimped parts may vary with the crimping dies.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 5-3.
5 Appendix
Figure 5-3.
Figure 5-4.
41