Huawei AP3010DN-AGN Hardware Installation And Maintenance Manual page 34

Huawei AP3x10xN&5x10xN&5x30xN&6x10xN&7x10xN
Hardware Installation and Maintenance Guide
Product Model
AP7110DN-AGN
AP7110SN-GN
Table 2-4
Table 2-4 Cable connections of indoor APs
No.
1
2
3
4
5
Issue 11 (2015-05-18)
Appearance
1
describes cable connections of indoor APs.
Cable
5 GHz antenna cable
2.4 GHz antenna
cable
Dual-band antenna
Ground cable
Network cable
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Console ETH/PoE
4 5
Console ETH/PoE
4 5
Description
Connects a 5 GHz antenna to the AP to send
and receive service signals.
Connects a 2.4 GHz antenna to the AP to send
and receive service signals.
Connects a dual-band antenna to the AP to
send and receive service signals.
Grounds the AP. The M4 connector of the
ground cable is connected to the AP and the
M6 connector is connected to the protection
ground.
l The network cables used are category-5
enhanced or higher twisted pairs.
l Ensure that the AP is connected to the
Ethernet using the Ethernet cable that
works properly. If the Ethernet cable is not
working properly, for example, RJ45
connectors are short-circuited, the AP
may fail to be powered on or fail to work.
Before connecting an Ethernet cable to the
AP, use the cable test tool to check
whether the cable is qualified. If the cable
is unqualified, replace it.
2 AP Installation
Default DC 12V
6
Default DC 12V
6
2
2
27