Appendix - Huawei AP3010DN-AGN Hardware Installation And Maintenance Manual

Huawei AP3x10xN&5x10xN&5x30xN&6x10xN&7x10xN
Hardware Installation and Maintenance Guide
5.1 On-site Cable Assembly and Installation
5.1.1 Cable Assembly Precautions
Checking the Appearance of Cables
l
l
l
l
Checking the Appearance of Connectors
l
l
l
Precautions for Assembly
l
l
l
Issue 11 (2015-05-18)
If the cable jacket or insulation is visibly dirty, clean it before assembly.
If the jacket or insulation of a cable has visible damage, irreparable scuffing, or other
defects, do not use the cable.
If the shield layer of a cable is damaged, do not use the cable.
If the cable jacket or insulation cracks after the cable is bent or twisted, discard this cable
and check whether other cables have the same problem. If other cables have the same
problem, replace these cables.
Do not use connectors with visible defects, damage, rust or scuffing.
Do not use connectors if their shells or pins have exposed part or uneven plating, or their
pins are lost, broken, or bent.
Do not use connectors that have dirt on their pins or in their jacks or if there are conductors
between pins or between pins and the shell.
Use dedicated tools or tools delivered by Huawei and follow the methods given here during
assembly.
Hold terminals of cables instead of pulling the cables when installing or removing cable
components.
Take the following precautions when cutting or stripping cables:
– Make cables slightly longer than necessary.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.

5 Appendix

5
Appendix
38