Create New Tool - Siemens SINUMERIK 840D Operator's Manual

09.01
3.11.7

Create new tool

© Siemens AG, 2001. All rights reserved
SINUMERIK 840D/810D Configuring the OP 030 Operator Interface (FBO) – 09.01 Edition
1. Select the softkey "New tool" in the tool list display.
Fig. 3-25 Create new tool
2. You need to enter the following data:
−
Tool identifier (16 characters)
−
Duplo number (1 character)
−
Tool type (3 characters)
−
Location type (1 character)
−
Size in half-locations: 1-character input fields (1..7) for
left, right, top, bottom
The tool does not need to be assigned to a location yet. In some
cases, it is only set up in the tool management memory and will be
loaded to a location later on.
3. Your inputs are accepted when you select softkey "OK", the Tool
Data screen appears.
Fig. 3-26 Tool data
The following additional data can be input:
S: Cutting edge number
Can be incremented with the softkey "C-edg plus"
(1 character). You can generate further cutting
edge numbers (max. 9) with the softkey "New C-
edg".
Geo: Geometry data (8 characters)
Wear: Wear data (8 characters)
Operator's Guide (BA)
3 Operation
BA/3-35