Siemens SINUMERIK 840D Operator's Manual page 64

Development Kit (EU)
2 Installation
Continuing to use
the Workbench
working
environment
Typical errors
during setup
EU/2-10
The Visual Workbench saves information about your current working
environment (open files, search and replace character strings, etc.) in
<project>.wsp files which are stored alongside your <project>.mak.
Copy these files - but do not copy *.vcw and *.mak - from your previous
configuration environment to the newly installed environment.
Copy the files you have modified and newly created files. To do this,
refer to the files and directories listed in Section 4.1.
Scenario: Neither the Windows File Manager nor the DOS
"deltree" command can delete the directory
<Ziellaufwerk>\OP 030.
Cause: You still have a "substitute" on this drive.
Remedy: Exit Windows and delete the "substitute" with subst
l: /d.
Scenario: Commands or files are not found.
Cause: You have probably appended a space at the end of
the following set command in op030set.bat
"set TOOLROOTDIR=<MSVC_DIR>".
Remedy: Delete the space at the end of the set command.
Move to the end of the line using the <END> key on
the cursor control pad.
SINUMERIK 840D/810D Configuring the OP 030 Operator Interface (FBO) – 09.01 Edition
© Siemens AG, 2001. All rights reserved
09.01