Software Update: Basic Information; Hw And Sw Requirements - Siemens SINUMERIK 840D Operator's Manual

Development Kit (EU)
2 Installation
2.1

Software update: Basic information

2.2

HW and SW requirements

EU/2-8
See documentation on Screen Kit.
•
Standard PC with a 80386 processor or higher(80486
recommended), 8MB main memory, 3 1/2 inch disk drive and a
standard VGA graphics card (min. resolution 640x480 pixels)
•
Memory requirements for the OP 030 environment (configuration,
PC simulation, system for OP 030 hardware) approx. 6MB on hard
disk.
•
MS-DOS 5.0 or higher (or a similar DOS version)
•
Windows 3.1 or Windows for Workgroups or W9x
•
Microsoft Visual C/C++ V1.0 or V1.52 (can no longer be purchased
from Microsoft but, if required, a rudimentary version without the
Workbench can be obtained from Siemens).
•
Main memory:
The OP 030 PC simulation requires a minimum of 500KB of
conventional main memory (in the area between 0–640KB).
If you are running the OP 030 PC simulation with an MPI interface
on an NCK, this free memory must be available after the
communications driver has been loaded (by calling "com030.bat",
see below).
SINUMERIK 840D/810D Configuring the OP 030 Operator Interface (FBO) – 09.01 Edition
© Siemens AG, 2001. All rights reserved
09.01