Siemens SINUMERIK 840D Operator's Manual page 88

Development Kit (EU)
4 Extending the Application Configuration
4.1.11 List identifiers for application area – ap_mwl.h
Description
4.1.12 List identifiers for standard user area – std_mwl.h
Description
EU/4-34
All of the list identifiers for all the configuration lists used in the
application user area are contained in L:\proj\h\ap_mwl.h.
The list identifiers are listed as an enum symbol in an enum list; new
symbols are appended in a similar way as the existing entries.
These symbolic enum identifiers are then used in the configuration
source files for the definition and call(s) of the list.
The starting range of the enum list may not be changed, since the
list identifiers will otherwise collide with the standard user area.
See also:
Reference: /FBO/, PS, Configuring Syntax
All of the list identifiers for all of the configuration lists used in the
standard user area are contained in L:\proj\h\std_mwl.h.
The list identifiers are listed as an enum symbol in an enum list.
These symbolic enum identifiers are then used in the configuration
source files for the definition and call(s) of the list.
The starting range of the enum list may not be changed, since the
list identifiers will otherwise collide with the application area.
See also:
Reference: /FBO/, PS, Configuring Syntax
SINUMERIK 840D/810D Configuring the Operator Interface OP 030 (FBO) – 09.01 Edition
© Siemens AG, 2001. All rights reserved
09.01