Development Kit (EU)
3 First Steps in Configuring
3.1
First complete compilation
EU/3-20
•
To check the setup process, first start the
OP 030 software in PC simulation mode:
Command sequence:
L:
cd \bin
op030
Switch to application configuration with the "Area Switchover key"
(F10 on the PC) and the "Continue" and "Config" softkeys.
Only the "Application text" is displayed here.
Exit the PC simulation with the key sequence
<CTRL><x> (simultaneously) <ENTER>
•
Start Windows and the Visual C++ Workbench.
•
Select <Project> -> <Open> to open the makefile L:\proj\makefile.
•
Start the complete compilation with <Project> -> <Build> PROJ.
Alternatively, without starting the Workbench, initiate the command
"nmake" in the \proj catalog.
•
If the complete compilation is performed correctly, the following
message appears in the output window:
"LINK: warning L4021: no stack segment
LINK: warning L4038: program has no starting address
copy proj.dat l:\bin\proj.dat
1 file(s) copied
MAKEFILE - 0 error(s), 2 warning(s)"
The 2 warnings always occur when proj.dat is linked and can be
ignored.
•
A proj.dat and all *.sp1,2 files with the current date must now be
located in the L:\bin directory. Only sytx.sp1,2 are not changed.
•
Test the system by reloading the OP 030 software in PC simulation
mode.
SINUMERIK 840D/810D Configuring the OP 030 Operator Interface (FBO) – 09.01 Edition
© Siemens AG, 2001. All rights reserved
09.01