Pbx Configuration-[1-1] Configuration-Slot-V-Ipcs4-Card Property - Panasonic KX-NS1000 Pc Programming Manual

9.18 PBX Configuration—[1-1] Configuration—Slot—V-IPCS4—Card Property
9.18 PBX Configuration—[1-1]
Configuration—Slot—V-IPCS4—Card Property
The properties of the V-IPCS card can be specified.
Signaling (PTAP) UDP Port No. (Server)
Specifies the UDP port used by the V-IPCS card to transmit and receive PTAP (Panasonic Telephony
Administration Protocol) data. This must be changed if another network application is using the same port.
To change the value displayed here, click Common Settings and set the desired value.
Default
39300
Value Range
1024–65535
Maintenance Console Location
9.18 PBX Configuration—[1-1] Configuration—Slot—V-IPCS4—Card Property
Signaling (MGCP) UDP Port No. (Server)
Specifies the UDP port used by the V-IPCS card to transmit and receive MGCP (Media Gateway Control
Protocol) data. This must be changed if another network application is using the same port.
To change the value displayed here, click Common Settings and set the desired value.
Default
32727
Value Range
1024–65535
Maintenance Console Location
9.18 PBX Configuration—[1-1] Configuration—Slot—V-IPCS4—Card Property
Signaling (MGCP) UDP Port No. (IP-CS)
Indicates the UDP port used to transmit and receive MGCP (Media Gateway Control Protocol) data on the
IP-CS side (reference only).
Default
2427
Value Range
2427
Maintenance Console Location
9.18 PBX Configuration—[1-1] Configuration—Slot—V-IPCS4—Card Property
390 PC Programming Manual Document Version 2016-03