Interface Description - Siemens SINUMERIK 840Di Manual

06.03
2.13.2

Interface description

Interface overview
External power
supply
(X1)
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
2.13 ADI4 (analog drive interface for 4 axes) (SW 09.01 and higher)
Interfaces of the ADI4 module
Table 2-24 Interface overview: ADI4
Interface
External power supply +24V
PROFIBUS DP
PROFIBUS DP address
Analog setpoint interface
Encoder connection for axis 1
Encoder connection for axis 2
Encoder connection for axis 3
Encoder connection for axis 4
Digital outputs
Digital inputs
Module status
Interface description of the external power supply (X1):
S
Connector: Three-way connector MSTB 2.5/3-ST-5.08, Phoenix
S
Pin assignment.
Table 2-25 Pin assignment: Ext. power supply (X1)
Pin Designation
1 P24EXT1
2 M24EXT1
3 PE
1) VI Voltage Input
S
Connecting cable
The required connecting cables must be provided by the user:
– Wire, conductor cross-section: 1.0–1.5mm
S
Supply voltage
For specification of the supply voltage, see Subsection 2.13.4, page 2-119.
2 Hardware Descriptions
Designation Type
X1 Connector
X2 Socket connector
S2 DIL switch
X3 Connector
X4-1 Socket connector
X4-2 Socket connector
X5-1 Socket connector
X5-2 Socket connector
X6-1 Connector
X6-2 Connector
H1/H2 LEDs
1)
Type
VI External power supply of the module (+24V)
VI Reference for external power supply
VI Protective conductor of the external power supply
2
(AWG17–AWG16)
Function
2-107