Siemens SINUMERIK 840Di Manual page 416

12 Dry Run of Axis and Spindle
12.3 Dry run of spindle
IS
"Spindle in
setpoint range"
(DB31–DBxx,
DBX83.5)?
Change over
gear stage
no All gear
stages tested?
Position
spindle?
Position
reached off:
1. Higher speed
2. Zero speed
Change over
gear stage
All gear
no
stages tested?
End
12-416
1
Check machine data and interface signals
MD 35110–35140
no
MD 35150
IS "Actual gear stage" (DB31-DBxx, DBB16)
IS "Select drive parameter set" (DB31-DBxx, DBB21)
IS "Setpoint gear stage" (DB31-DBxx, DBB82)
IS "Active drive parameter set" (DB31-DBxx, DBB93)
yes
yes
no
End
yes
Check machine data
MD 36000
no MD 36010
MD 32200
MD 35210
MD 35300
MD 36300
MD34200
MD of encoder matching
yes
yes
Speeds for gear stages
Spindle speed tolerance
Coarse exact stop
Fine exact stop
K factor
V
Acceleration in position control range
Creep speed
Encoder limit frequency
Spindle synchronization
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
06.03
J