Siemens SINUMERIK 840Di Manual page 142

5 MPI Communication
5.4 Machine control panel (MCP)
Display of
software version
10
1000
Left key/LED group
Fig. 5-5 MCP software version display
Data transfer rate
MPI address
5-142
For a detailed description of the electrical and mechanical design and of the
MCP interfaces, please refer to:
References: /BH/ Operator Components, Manual
Section: Machine control panel (MCP)
After the MCP has been electrically connected, all LEDs on the front side of the
MCP flash until no communication takes place between MCP and PLC.
Simultaneously pressing the two keys "Feed stop" and "Feed enable" (in the
bottom right corner) displays the version number of the current software version
using the LEDs now lighting continuously.
Version number = V "Number of lighting LEDs in the left LED group"
"Number of lighting LEDs in the middle LED group"
"Number of lighting LEDs in the right LED group"
Version number V4.1.5 is displayed in the example (Fig. 5-5).
[.]
1
100
10000
Right key/LED group
Middle key/LED group
LED ON LED OFF
The data transfer rate is set using switch S3 on the rear side of the MPI module.
It is 1.5 Mbaud on the MPI bus of the SINUMERIK 840Di.
Setting on S3: see Table 5-1, page 5-143.
The factory-set MPI address of the MCP is 6
The MPI address of the MCP can be set using switch S3 on the rear side of the
MCP.
Setting on S3: see Table 5-1, page 5-143.
+X +C
+Y
+Z
–Z
–X
–C –Y
%
Enable software version display
(both keys simultaneously)
(D = decimal).
D
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
06.03
%