Siemens SINUMERIK 840Di Manual page 176

6 Turning On and Ramp Up
6.2 First ramp-up
Completion
6-176
Menu commands:
S
Install NOW
All the applications displayed will be installed in the listed order. During the
installation procedure follow the instructions that appear on the screen.
Notice
You must not switch off the PCU during the entire installation procedure. Loss
of data!
S
Install at NEXT REBOOT
None of the listed applications are installed and you go to the NT Desktop.
The installation menu is displayed again the next time the PCU is booted.
S
CANCEL installing
None of the listed applications are installed.
Notice! It is not possible to repeat the installation process at a later time.
Notice
The installation menu is not displayed the next time the PCU is booted. It is
not possible to repeat the installation process.
Once the PCU has powered up again, you can continue with the basic start-up
procedure of the PLC (Subsection 6.2.3, page 6-179).
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
06.03