General - Siemens SINUMERIK 840Di Manual

06.03
PREFACE
Notes for the
Reader
Hotline
Internet address
SINUMERIK
SW version
Target readers
Objective
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
The SINUMERIK documentation is divided into three levels:
S
General documentation
S
User Documentation
S
Manufacturer/Service Documentation.
For more information about the SINUMERIK 840D/810D/FM-NC documentation
as well as documentation for all SINUMERIK controls, please contact your local
SIEMENS office.
If you have any questions about the control, please contact the hotline:
A&D Technical Support
Please send any questions about the documentation (suggestions forimprove-
ment, corrections) to the following fax number:
Fax form: see reply at the end of the manual
http://www.ad.siemens.de/sinumerik
The SW versions stated in the documentation apply for the SINUMERIK 840Di
control.
S
Configuring engineers,
S
Electricians and start-up specialists
S
Service and operating personnel.
This manual provides detailed information on the specific hardware and start-
up/installation of a SINUMERIK 840Di system.
This manual provides information about the control system design and the
interfaces of the individual components. Furthermore, the procedure for starting
up the SINUMERIK 840Di with PROFIBUS DP drives (in particular SIMODRIVE
611 universal) is described.
For detailed information about individual functions, function assignment and
performance data of individual components, please refer to the appropriate
document for the subject concerned (e.g. manuals, function descriptions etc.).
User-oriented activities such as the creation of parts programs and control
operating procedures are described in detail in separate documentations
(Programming Guide, Operator's Guide, etc.).
SINUMERIK 840Di Manual
Phone: +49–180–5050–222
Fax: +49–180–5050–223
E-mail: adsupport@siemens.com
Fax: +49 (9131) 98–2176
Preface
v