Siemens SINUMERIK 840Di Manual page 301

06.03
Windows NT
system settings
 Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
The following Windows NT system settings are required:
1. Startup / Shutdown
Windows NT start bar: Start > Settings > Control Panel > System > Tab:
Startup/Shutdown
System Properties
General
Startup/Shutdown
System Startup
Startup: "SINUMERIK" /NoSerialMice
Show list for: 3
Recovery
When a STOP error occurs, do the following:
Write an event to the system log
Send an administrative alert
Write debugging information to:
D:\Memory.dmp.
Overwrite any existing file
Automatically reboot
Fig. 10-4 Dialog: Windows NT system settings
The following settings must be made:
– Option: "Write debugging information to:" selected
– Drive and file specified.
The file should preferably reside on drive D: to prevent it being stored in
a ghost image, and the file name must be valid according to Windows
NT file name conventions.
– Option: "Overwrite any existing file" selected
If settings are incorrect, the following message box appears:
SINUMERIK 840Di NCK/PLC
Alarm: Wrong Windows "System Properties" settings for Recovery.
10 NC Start-Up with HMI Advanced
10.4 Memory configuration
Performance
Hardware Profiles
OK Cancel
OK
Environment
User Profiles
10-301