Parameter Window Time Switch Standard - Settings - ABB i-bus KNX Product Manual

®
ABB i-bus KNX
Commissioning
Parameter window Time switch Standard – Settings
The settings for the time switch Standard are made in this parameter window. A switching signal can be
sent on the bus and cancelled again at a certain time with this simple (daily) time switch. This allows the
exterior lighting to be switched on/off at the same time each day, for example. The first and second
switching times can be enabled in this window.
Time switch
Options:
The time switch is enabled with this parameter.
•
Inactive: The time switch is deactivated.
•
Active: The 1-bit object Sends time switch Standard – Sending is activated. The dependent parameter
window 1st switching time is displayed. The "On" value is sent via the object at the switch-on time
parameterized there, and the "Off" value is sent at the parameterized switch-off time.
2nd switching time
Options:
A second switch-on time can be set for the time switch with this parameter.
•
Inactive: The 2nd switching time is deactivated.
•
Active: The following parameters are displayed. The dependent parameter window 2nd switching time
is displayed. The "On" value is sent via the object at the switch-on time parameterized there, and the
"Off" value is sent at the parameterized switch-off time. Overlaps with already parameterized times in
the 2nd switching time parameter window can occur.
Inactive
Active
Inactive
Active
TR/A 1.1 | 2CDC509082D0201 29