Parameter Window Temperature -Temperature Control - ABB i-bus KNX Product Manual

Time receiver gps, tr/a 1.1

Hide thumbs Also See for i-bus KNX:

Table of Contents

ABB i-bus

KNX

Commissioning

Parameter window Temperature –Temperature control

The parameter window is used to make the temperature control settings. Simple (outside) temperature-

dependent control can be implemented with temperature control. The measured temperature is compared

with a pre-parameterized threshold here, and the output object is switched over correspondingly. A 1-bit

switching object or a 1-byte scene object is available as the output object here. They can be used to

decide whether to switch the heater on or off, for example.

Temperature threshold

Options:

•

58 2CDC509082D0201 | TR/A 1.1

Inactive

Active

Inactive: Temperature control is deactivated.

Active: Temperature control is activated. The following dependent parameters and the dependent

object Sends temperature above/below setpoint temperature – Sending are displayed.

Table of Contents