ControlMaster CM15 and CMF160
Universal process indicator
...Device Setup / ...Initial Setup
Config Action
Continue
Hold
Inactive
Level 1 (2) Indicator*
Specific Gravity
Volume Constant
Volume Units
Volume DPs
*See Section 8.2.4, page 84 for examples of volume calculations.
IM/CM/I–EN Rev. P
1
/
DIN
8
The Config Action parameter is used to determine how the indicator and indicator outputs behave
when the Advanced level is entered – see page 34.
The indicator continues to operate as in Operator level. Outputs continue to operate as normal.
Digital, relay and analog outputs are held at their value / state when Configuration mode is
entered. When the Advanced level is exited, the indicator returns to the pre-Configuration mode
of operation.
Analog outputs are set to 0 mA. Relays de-energized, digital outputs inactive.
Note. Applicable to level applications only.
Value of the specific gravity currently applied to the process variable.
The constant used to calculate the volume (maximum value 999.9).
The unit of measure used to calculate the volume.
The number of decimal places required (maximum of 4).
7 Advanced Level
35