ABB ControlMaster CM15 User Manual page 57

ControlMaster CM15 and CMF160
Universal process indicator
...Totalizer
Count Direction
Up
Down
Units
Count Rate
Cutoff
Stop Go Source
IM/CM/I–EN Rev. P
1
/ DIN
8
Totalizer value increases with time.
Totalizer value decreases with time.
(Totalizer) units are used along with the source's units and engineering range to calculate the
count rate automatically (where possible). Where the units or mode required do not allow this, the
count rate must be calculated manually – see Section 7.5.1, page 57.
In mode, this represents the counts (in volume units) / second when the source is at its
Analog
engineering high value.
In , and
Digital Frequency Pulse
units / pulse.
The lowest input value (in engineering units) the totalizer stops counting at.
The source required to stop and start the totalizer. Selection is made on the rising edge:
Start Stop
mode (see page 54) this represents the number of totalizer (volume)
7 Advanced Level
55