ControlMaster CM15 and CMF160
Universal process indicator
...Device Setup / ...Initial Setup
Custom Template
Analog 1 Eng. Units
Analog 2 Eng. Units
Tot. 1 Eng. Units
Tot. 2 Eng. Units
Stats. Reset Source
Reset to Defaults
Security Setup
Basic Password
Advanced Password
Reset Passwords
36
1
/
DIN
8
If this parameter is enabled, it enables the internal function blocks to be re-linked to create custom
configurations for special application requirements.
These sources are configured in Device Setup / Custom Config – see page 37.
Configurable units that can be assigned to any analog signal
(Analog I/P or Math Block).
Configurable units that can be assigned to any totalizer.
Sets the digital source signal used to reset the statistics.
Resets all configuration parameters to their default values.
2 Security access levels are provided, each protected by a password of up to 6 alphanumeric
characters.
Note. Passwords are not set at the factory and must be entered by the end user(s).
Basic level provides access to the Basic level.
Provides access to Advanced configuration parameters – see Section 7, page 34.
Resets all passwords to factory values.
7 Advanced Level
IM/CM/I–EN Rev. P