Device Info - ABB Endura AZ series User Manual

Endura AZ series integral and remote transmitter
Combustion oxygen monitor

5.4.9 Device Info

Menu
Device Info
Exit
Parameter
Serial Number
Date of Manufacture
Date of Last Cal.
Probe Type
AZ20 & Integral Tx
AZ20 & Remote Tx
AZ25 & Remote Tx
AZ30 & Integral Tx
AZ30 & Remote Tx
AZ35 & Remote Tx
AZ10 With Filter
AZ10 No Filter
Autocal Hardware
None
Internal
Remote
Transmitter Options
None Fitted
Digital I/O
Analog Output
Main Board Version
Software Version
*For marine application Exhaust Gas Recirculation (EGR) transmitters, the probe type is set to AZ10 No
Filter and cannot be changed.
Table 5.14 Device Info
IM/AZ20E–EN Rev. F
Identifies the transmitter's serial number, transmitter's date of
9
manufacture, the last oxygen calibration date, the probe type,
the transmitter options card (if fitted), AutoCal hardware (if
fitted) and main board and software version numbers.
Note. Parameters in this menu are read-only.
Select
Comment / [Range]
The serial number of the transmitter.
The time and date the transmitter was manufactured.
The date of the last oxygen calibration.
Note. The date is updated automatically against the
date set in the transmitter.
The probe type used with the transmitter.
The automatic calibration system configured for use
with the transmitter.
Disables automatic calibration functions.
Enabled if the (optional) built-in automatic calibration
is fitted.
Enabled if an external automatic calibration system is
used.
The transmitter option card fitted.
The main PCB hardware version.
Displays the version of software installed on the
transmitter.
5 Programming
Default
Factory-set
Factory-set
N / A
AZ20 &
Remote Tx*
None
Factory-set
Factory-set
Factory-set
63