Operator Menu - ABB Endura AZ series User Manual

Endura AZ series integral and remote transmitter
Combustion oxygen monitor

5.2.2 Operator Menu

Operator Menu
Diagnostics
Operator Page 1
Operator Page 2
Autoscroll
Signals View
Back
Display Overview
Sensor
–– F098.001 ––
TEMP SENSOR
FAILED
Check related
diagnostics
check wiring.
Back
21.0
O2
12.00
TMP
O/P
Sensor
Operator Menu
Diagnostics
Operator Page 1
Operator Page 2
Autoscroll
Signals View
Table 5.3 Operator Menu Screens
28
The Operator Menu is used to view:
1



Select
Note. It is not possible to configure the system or to modify
data from the Operator Menu.
Section and Function
Diagnostics

From the Operator Menu, press
menu that displays active diagnostic system data.

Use the
active diagnostics.
Exit

Refer to Section 8.2.1, page 79 for diagnostic messages.
Operator Page 1 (2)
%O2

Two Operator pages are available – Operator Page 1 is always
enabled, Operator Page 2 can be set to OFF or enabled.
°C
0%
When Operator Page 2 is enabled, it is listed in the
Operator Menu.

Setup of the two Operator pages is performed at the Display
menu by selecting pre-configured display options – see
Section 5.4.5, page 48.
Autoscroll
4

When enabled the 2 Operator pages (1 and 2) are toggled at
10-second intervals, providing on-screen monitoring of up to 6
parameters.

Once selected, the transmitter remains in Autoscroll mode
Select
until Operator Page 1 or Operator Page 2 is selected. If
Operator Page 2 is set to Off, or AutoScroll is set to Disabled,
Operator Page 1 is displayed.
a list of current alarms (from the Diagnostics option)
Operator Page 1 only, Operator Page 2 only or, if
Autoscroll is enabled, the two page views are toggled at
10-second intervals.
active signals and their values (from the Signals View
option)
and keys to scroll through
5 Programming
to select the Diagnostic
IM/AZ20E–EN Rev. F