NEC Express5800 Maintenance Manual page 81

Chapter 2 Convenient Features
For details about the options, see the table below.
Option
iSCSI Attempt Name
iSCSI Mode
Connection Retry Count
Connection Timeout
ISID
Enable DHCP
Initiator IP Address
Initiator Subnet Mask
Gateway
Target info via DHCP
Target Name
Target IP Address
Target Port
Boot LUN
Authentication Type
CHAP Type
CHAP Name
Express5800/A1040b, A2040b, A2020b, A2010b Maintenance Guide
Parameter
Alphanumeric Specify the Attempt name.
characters (up to 96
characters)
[Disabled] Enable (with or without MPIO) or disable iSCSI.
Enabled In MPIO (iSCSI Multipath I/O), alternate data paths to iSCSI
Enabled for MPIO storage can be provided and multiple Attempts can be
configured. If connection of any one of Attempt fails, an alternate
Attempt can be used for connection.
Number (0 to 16) Specify the number of retries at connection failure. Allowable
retry count is 0 to 16. 0 means that retry is not performed.
Factory setting is 0.
Number (100 to 20000) Specify connection timeout value in millisecond. Allowable value
is between 100 and 20000 milliseconds (20 seconds). The
factory setting is 1000 milliseconds.
Alphanumeric Specify ISID with 6-digit characters. Default setting is the value
characters (MAC of MAC address. Enter the value for lower 3 bytes among 6
address format) bytes.
[Disabled] Enable or disable DHCP.
Enabled
Number (IP address Specify IP address of iSCSI Initiator.
format) (Example: 192.168.1.1)
Number (IP address Specify subnet mask of Initiator.
format) (Example: 255.255.255.0)
Number (IP address Specify gateway IP address.
format) (Example: 192.168.1.254)
[Disabled] Enable or disable to acquire information of iSCSI target through
Enabled DHCP, if DHCP is enabled.
Alphanumeric When Target info via DHCP is disabled, specify the name of
characters iSCSI target with IQN format.
(Example: iqn.2001-03.jp.nec:target)
Number (IP address Specify the IP address of iSCSI target.
format)
Number Specify the port number of iSCSI target. The factory setting is
"3260".
Number (character Specify the LUN (Logical Unit Number) of iSCSI target. The
string between 1 to 20 factory setting is "0".
characters)
[CHAP] Specify authentication type for iSCSI connection.
None
[One way] Specify the authentication type when CHAP is selected for
Mutual authentication of iSCSI connection.
One way: Only iSCSI target authenticates iSCSI Initiator.
Mutual: iSCSI target and iSCSI Initiator authenticate each other.
Alphanumeric Specify CHAP Name that the target authenticates.
characters (up to 16
characters)
1. System BIOS
Descriptions
81