Intelligent Monitor Software (Gp-Xaim) (Optional) - Panasonic GP-X Series User Manual

6.3 Intelligent Monitor Software (GP-XAiM) (Optional)

With the optional intelligent monitor software (GP-XAiM), the measurement
data can be easily analyzed or saved at your PC while conditions can be
entered, saved or loaded.
Use these features together with the data buffering function of the controller
to acquire ready-to-analyze data assuredly.
For details, contact us.
To use the intelligent monitor software (GP-XAiM) correctly
Preparation for operation of GP-XAiM
Before operating GP-XAiM, check the following.
[1] In the case of operation of a network with linked controller
communication units (GP-XCOM)
(1) Set the terminator switch of each GP-XCOM correctly.
(2) Use "Auto" for address assignment of GP-XCOM.
If "Auto" is not used, addresses may not be recognized correctly.
[2] Preparation necessary after startup of GP-XAiM before online
operation is started
(1) Enter the same RS-232C communication settings of the PC as
those of the controller.
(2) For details, refer to "help" of GP-XAiM.
Approximate time for loading buffered data
To buffer data using GP-XAiM, the data acquisition interval varies
according to the relationship between the data size to be acquired and the
transmission speed of RS-232C. When buffering, refer to the relationship
shown below as a measure.
The initial setting of the transmission speed of the controller is 19,200
bps. To perform buffering, change to a faster transmission speed.
Loading from controller connected with RS-232C cable
Baud rate
(bps)
19,200
57,600
115.2k
Note: The intelligent monitor software (GP-XAiM) witch can be used with
GP-XC22KL(-P) has been released. (With 2.00 or later version
software.)
132
No. of buffered data pieces
5,000 points 10,000 points
8 sec.approx. 16 sec.approx. 1 min. 20 sec. approx.
4 sec.approx. 8 sec. approx. 40 sec. approx.
3 sec.approx. 6 sec. approx.
50,000 points
30 sec. approx.