Error Indication List - Panasonic GP-X Series User Manual

7.1 Error Indication List

Error indication
Upper line Lower line
134
Alarm
Description of error
output
EEPROM data
ON
loading error
EEPROM data
ON
writing error
Memory switching
ON
error
Broken sensor head
ON
cable
There is a short circuit
in external output
circuit.
Short circuit
protection functions.
Three-point calibration
is incorrect.
The correction data
ON after three-point
calibration is incorrect.
The following equation
of the upper and lower
limit values stands
true:[(Upper limit value)
- (hysteresis width)] <
[(Lower limit value) +
(hysteresis width)]
The following equation
of the hysteresis width
stands true:[(Upper
limit value)
(hysteresis width)] <
[(Lower limit value) +
(hysteresis width)]
The trigger level
exceeds the setting
range.
The sum of the trigger
level and trigger
hysteresis exceeds
the setting range.
Display scale error.
This error occurs if the
same distance
displayed value
entered for the first
and second points. Or
a value beyond the
range is entered or the
inclination is too large.
Remedy
Turn the power off then
on again. If the error
persists, initialize settings
(to restore factory
shipment settings) and
enter settings again.
After resetting, initialize
settings and enter setting
again.
Check the wiring and
connect again.
Check the wiring and
connect again.
Perform adjustment again.
Perform adjustment again.
Enter correct values.
-
Enter correct values.
Enter the correct value.
Setting range:
0mm to 110% of F.S.
E n t e r c o r r e c t va l u e s.
S e t t i n g r a n g e :
0mm to 120% of F.S.
or
Enter the correct scale.
is
Distance setting range:
0mm to 110% of F.S.
Resetting key
Press and hold
.
Or enter an external
reset signal.
Press and hold
.
Or enter an external
reset signal.
Automatic recovery
Automatic recovery
P r e s s .
P r e s s .
P r e s s .
P r e s s .
P r e s s .
P r e s s .
P r e s s .