Kenwood TK-5810 Service Manual page 14

TK-5810 BG
(
KRK-5 main panel
Affix the sheet while
taking note of the position
of the three parts.
2-2. Installing the KRK-5 rear panel onto the front
panel kit
The following steps apply to both the KCH-14 and KCH-15.
1. Remove three screws q on the KRK-5 rear panel, then
remove the KRK-5 sub panel.
2. Insert the lead wire with connector (W102) of the KRK-5
into the connector (CN1) of the front panel kit w.
3. Insert the lead wire with connector (W103) of the KRK-5
into the connector (CN3) of the front panel kit e.
4. Make a slight cut in the end of the rubber cap r.
5. Slide the lead wire of the connector wiring t through
the slit in the rubber cap y.
6. Insert the rubber cap into the hole of the KRK-5 rear
panel u.
7. Insert the connector i to the ACC connector o on the
KRK-5 sub panel as shown by the arrow !0 .
8. Install the KRK-5 sub panel onto the sub panel of the
front panel kit !1 .
9. Install the KRK-5 sub panel to the sub panel of the front
panel kit using four screws !2 .
10. Reinstall the KRK-5 rear panel using three screws re-
moved in step 1.
11. Use a wire band to secure the lead wire at the end of the
rubber cap !3 .
Front panel kit
(Example : KCH-14)
CN1
CN3
W103
3
1
Rubber
Make
cap
a cut
14
/5810H BG
) ( )
INSTALLATION
Fig. 2-1-2
Packing
Sub panel
KRK-5 sub panel
KRK-5 rear panel
W102
Lead wire
IGN,
GND etc.
IGN,GND etc.
Fig. 2-2
2-3. Control cable (KCT-22) connection (Fig. 2-3)
1. Insert one connector of the control cable to the trans-
ceiver (with KRK-5) and the other to the display. Connect
the cable to the GND terminal with the screw q sup-
plied with the control cable.
2. Secure the one connector of the control cable to the
KRK-5 main panel with two screws w according to the
installation condition of the transceiver. Secure the con-
trol cable to the KRK-5 main panel with the cable fi tting
(J21-4354-04) and two screws e supplied with the KRK-
5.
3. Secure the other connector of the control cable to the
display with two screws r in the same way.
Transceiver
KRK-5 main panel
Cable
fitting
Control cable
KCT-22
Fig. 2-3
2-4. Display installation (Fig. 2-4)
1. Install the display with the angle bracket (J29-0648-03)
q and two screws (N08-0526-04) w supplied with the
KRK-5.
Angle
bracket
Fig. 2-4
GND
Display
GND