Kenwood TK-5810 Service Manual page 16

TK-5810 BG
(
Cable
fitting
KCT-22
Control cable
4. Ignition Sense Cable (KCT-18: Option)
The KCT-18 is an optional cable to use the following func-
tions:
• Ignition function
The ignition function allows you to turn the transceiver's
power on and off with the ignition key of your car. When
you are driving with the ignition key on, the horn alert func-
tion is disabled.
• Timed power-off function
The timed power-off function turns the transceiver's
power off the time specified with the programming soft-
ware (KPG-95DG) after the ignition key is turned off. When
you are driving with the ignition key on, the horn alert func-
tion is disabled.
The ignition sense function and the timed power-off
function can be used at the same time.
4-1. Connecting the KCT-18 cable to the transceiver
1. Remove the short plug from the accessory connector (9-
pin) on the rear of the transceiver.
2. Insert the KCT-18 lead terminal into pin 1 (IGN) of the
short plug (9-pin).
3. Connect the short plug to the accessory connector (9-pin)
on the rear of the transceiver.
Note:
You must setup using the KPG-95DG.
16
/5810H BG
) ( )
INSTALLATION
Transceiver
KRK-6DH
main panel
GND
Display 1
GND
GND
Cable
fitting
KCT-22
Control cable
Fig. 3-2
4-2. Connecting the KCT-18 cable to the
KRK-5/6DH remote kit
1. Remove the square plug from the accessory connector
(12-pin) on the rear of the control head.
2. Cut off the end of the rubber cap (accessory), insert the
KCT-18 lead terminal into the rubber cap, and insert it
into pin 1 (IGN) of the square plug.
3. Connect the square plug and rubber cap to the accessory
connector (12-pin) on the rear of the control head, then
clamp the bottom of the rubber cap with the supplied tie
wrap.
Note:
You must setup using the KPG-95DG.
Short plug
(9-pin)
1
7
3
9
Fig. 4-1
Display 2
GND
Square plug
(12-pin)
3
1
Rubber cap
12
10
KCT-18
KCT-18
Fig. 4-2
Tie wrap
Cut