Kenwood TK-5810 Service Manual page 6

TK-5810 BG
(
5-2. Connection procedure
1. Connect the transceiver to the computer using the inter-
face cable and USB adapter (When the interface cable is
KPG-43A, the KCT-53U can be used.).
Note:
• You must install the KCT-53U driver in the computer to
use the USB adapter (KCT-53U).
• When using the USB adapter (KCT-53U) for the fi rst time,
plug the KCT-53U into a USB port on the computer with
the computer power ON.
2. When the POWER switch on, user mode can be entered
immediately. When PC sends command the transceiver
enter PC mode, and "PROGRAM" is displayed on the
LCD. When data transmitting from transceiver, the red
LED is lights. When data receiving to transceiver, the
green LED is lights.
Note:
The data stored in the computer must match the "Model
Name and Market Code" when it is written into the fl ash
memory.
5-3. KPG-43/KPG-43A description
(PC programming interface cable: Option)
The KPG-43/43A is required to interface the transceiver
to the computer. It has a circuit in its D-sub connector (KPG-
43: 25-pin, KPG-43A: 9-pin) case that converts the RS-232C
logic level to the CMOS level.
The KPG-43/43A connects the microphone jack of the
transceiver to the RS-232C serial port of the computer.
5-4. KCT-53U description (USB adapter: Option)
The KCT-53U is a cable which connects the KPG-43A to
a USB port on a computer.
When using the KCT-53U, install the supplied CD-ROM
(with driver software) in the computer. The KCT-53U driver
runs under Windows 2000, XP or Vista (32-bit).
5-5. Programming software KPG-95DG description
The KPG-95DG (ver. 6.10 or later) is the programming
software for the transceiver supplied on a CD-ROM. This
software runs under Windows 98, ME, Windows NT4.0,
2000, XP or Vista (32-bit) on a PC.
The data can be input to or read from the transceiver and
edited on the screen. The programmed or edited data can
be printed out. It is also possible to tune the transceiver.
6
/5810H BG
) ( )
REALIGNMENT
6. PC Tuning Mode
When making adjustment while in PC tuning mode,
modify the KPG-43/43A programming interface cable as de-
scribed below.
1. Remove the two screws from the plug cover, then lift
the cover from the plug.
2. Solder the lead wire onto the MIC tab on the PCB, and
the ground wire onto the ME tab.
• KPG-43
+ +
+
• KPG-43A
C2
Q1
D1
Q2
Q3
MIC
ME
3.
• KPG-43
Create a hole in the casing (as shown in the illustration)
then fi t the cable into the hole. Replace the cover and
secure it using the two screws.
Cable
MIC
ME
Create a hole