Kenwood TK-5810 Service Manual page 62

TK-5810 BG
(
Test Equipment Required for Alignment
Test Equipment
Standard Signal Generator
1.
(SSG)
2. Power Meter
3. Deviation Meter
Digital Volt Meter
4.
(DVM)
5. Oscilloscope
High Sensitivity
6.
Frequency Counter
7. Ammeter
AF Volt Meter
8.
(AF VTVM)
9. Audio Generator (AG)
10. Distortion Meter
11. Spectrum Analyzer
12. Tracking Generator
13. 4Ω Dummy Load
14. Regulated Power Supply
Caution
Since the RX AF output is a BTL output, there is a DC
Component. Isolate this with a capacitor or transformer as
shown in the fi gure.
MIC connector
(Front view)
1
2 12
3 11
4
10
9
5
6 8
7
1: SB
2: HK
3: ME
4: MIC
5: E
6: TRD
7: KVL
8: DM
9: BLC
10: PTT
11: NC
12: ES2
62
/5810H BG
) ( )
ADJUSTMENT
Frequency Range
Modulation
Output
Input Impedance
Operation Frequency
Measurement Range
Frequency Range
Measuring Range
Input Impedance
Frequency Range
Frequency Stability
Frequency Range
Voltage Range
Frequency Range
Output
Capability
Input Level
Measuring Range
Center frequency
Output Voltage
Test cable for microphone input
To AG
4 : MIC (WHT)
AF VTVM
3 : MICG (Shield)
Cable for BPF or MCF adjustment
• E30-3418-05 (for BPF ADJ)
• W05-1000-00 (for MCF ADJ)
Major Specifi cations
400 to 520MHz
Frequency modulation and external modulation
–127dBm/0.1µV to greater than –47dBm/1mV
50Ω
400 to 520MHz or more
Vicinity of 200W
400 to 520MHz
1 to 20V DC
High input impedance for minimum circuit loading
DC through 30MHz
10Hz to 1000MHz
0.2ppm or less
30A
50Hz to 10kHz
3mV to 3V
50Hz to 5kHz or more
0 to 1V
3% or less at 1kHz
50mV to 10Vrms
DC to 1GHz or more
50kHz to 600MHz
100mV or more
Approx. 4Ω, 30W
13.6V (TK-5810(BG)), 13.4V (TK-5810H(BG)) approx. 30A
(adjusted from 9 to 20V) Useful if ammeter equipped
E30-3313-08
2 : HOOK (GRY)
10 : PTT (BLU)
PTT SW
Cut
5 : PTT (BLK)
Test cable for speaker output