Kenwood TK-5810 Service Manual page 17

5. Voice Guide & Storage Unit
(VGS-1: Option)
5-1. Installing the VGS-1 unit in the transceiver
1. Remove the upper case and upper packing of the trans-
ceiver.
2. Attach two cushions to the VGS-1 as shown in fi gure.
Note:
Be sure not to cover the VGS-1 connector (CN1) with the
cushion.
3. Insert the VGS-1 connector (CN1) into the control unit
connector (CN411).
Note:
You must setup using the KPG-95DG.
VGS-1
Cushion
(G13-1992-04)
21 x 21 x 2.5mm
Cushion
(G13-1974-04)
21 x 21 x 1.0mm
CN411
Fig. 5
6. External Speaker (KES-5: Option)
The speaker output from the transceiver is as follows:
1. The KCH-14 has a built-in speaker (3W/8 ohms).
2. The KCH-15 does not have a built-in speaker.
3. The external speaker output from the accessory connec-
tor (9-pin) on the rear of the transceiver is 13W/4 ohms.
Use the KES-5.
4. The speaker output from the accessory connector (12-
pin) on the rear of the control head is 2W/4 ohms. If the
remote kit (KRK-5, KRK-6DH) is used, use the KES-5.
Note:
Since the transceiver uses a BTL audio amplifi er, do not
ground the speaker output pin.
INSTALLATION
CN1
TK-5810
6-1. Connecting the KES-5 external speaker to the
transceiver
• When taking the AF output from the accessory con-
nector (9-pin) on the rear of the transceiver
The following tools are required for changing the connec-
tor.
Extracting tool
The following extracting tool is recommended :
Molex Inc. Order No.: 11-03-0002
1. Remove the short plug from the accessory connector (9-
pin) on the rear of the transceiver (Fig. 6-1-1).
Note: Save the jumper, which is required when the trans-
ceiver is used without the external speaker.
2. Remove the terminals with the jumper from the connec-
tor housing holes number 3 and 6 using the extracting
tool.
Removing the jumper lead (Fig. 6-1-2)
1) Insert the extracting tool (11-03-0002) into the con-
nector while pushing the jumper lead in the direction
of (a).
2) Push the extracting tool into collapse the barbs of the
crimp terminal.
3) Pull out the lead while continuing to push the extract-
ing tool in the direction (b).
3. Reinsert the terminal with the black and white stripe lead
into hole number 2, and the terminal with the black lead
into hole number 6 (Fig. 6-1-3).
4. Connect the short plug to the accessory connector (9-pin)
on the rear of the transceiver.
Short plug
Extracting tool
(E37-0733-05)
(11-03-0002)
Fig. 6-1-1
Short plug
(9-pin)
1
7
9
6
Fig. 6-1-3
BG /5810H
( ) (
(a)
(b)
Jumper lead
Barbs
Crimp terminal
Fig. 6-1-2
2
To KES-5
Black/White lead
Black lead
BG
)
17