Table of Contents
Advertisement
No. 2D730-148E*O
A
- CAUTION:
2. Be sure to install the system on a level floor and lock the casters.
If this is
not done, the system may move, injuring
the service personnel.
3. Move the system forward
or backward
only.
If the system
is moved to the left
or right, it may fall, causing
injury.
In addition,
be sure to fix the moving
sections
such as the operating
panel before moving the system.
If such
sections
move, they may catch the hands or fingers of the persons
moving
the system,
possibly
causing
injury.
4. To prevent
electric shock, do not connect
the peripheral
units (video printer,
VCR, etc.) to an external
outlet.
Peripheral
units should
be connected
to the
service outlet of the system or the optional
isolation
transformer.
For the
connection
procedures,
contact
your TOSHIBA representative.
5. The service outlet of the main unit is intended
solely for recommended
peripheral
units.
Do not connect
devices other than recommended
peripheral
units to the service outlet.
Connecting
devices other than those
recommended
may cause the consumption
current to exceed the power
capacity
of the main unit, possibly
resulting
in malfunction.
6. Do not place any objects
on top of the monitor.
They may fall, causing
injury.
7. Do not allow fluids such as water to contact
the system or peripheral
devices.
Electric shock may result.
8. Do not handle the system with wet or moist hands.
Electric shock may
result.
9. The monitor
is a heavy unit.
Two persons
are required
when mounting
or
removing
the monitor.
If a worker
mounts
or removes
the monitor
alone,
he/she may be injured.
10. Be sure to turn OFF the power breaker and disconnect
the mains plug from
the outlet before removing
the covers of the main unit and performing
internal wiring.
11. When discarding
any part of this system,
follow all applicable
local
regulations.
12. Wear protective
gloves to ensure safety and prevent
infection
when
performing
unit replacement,
board replacement,
internal wiring,
or cleaning.
13. Wait at least 30 seconds
after turning
OFF the power breaker and
disconnecting
the mains plug from the outlet before replacing
the battery.
Otherwise,
an electric shock may result.
CAUTION:
I. When replacing the AC/DC tray of the SSA-770A, check the revision number of the
AC/DC tray supplied for replacement
and follow the appropriate
procedure according to
the revision number.
1 .I
When the new AC/DC tray is BSM31-2013E
(no revision)
The AC/DC tray is not compatible and must not be used to replace the existing tray.
s-3
Advertisement
Table of Contents
