UEN00228-04
Checking cab tipping stopper
a Since the cab tipping stopper is a safety part,
check it according to the following procedure.
1.
Remove the additional undercover from the
rear of the operator's cab.
a Perform this step only when the additional
undercover is installed.
2.
Check the tightening torque of the mounting
bolt (2) of the lock plate (1).
3
Bolt (2): 98 – 123 Nm {10 – 12.5 kgm}
[Reference]
The tightening torque of mounting bolt (4) of
q
cab tipping stopper (3) is different from that of
a common bolt 30 mm in diameter. Take care.
3
Bolt (4): 245 – 309 Nm {25 – 31.5 kgm}
58
1
30 Testing and adjusting
PC210, 230, 240-8