Installing The Intramail Pcb - NEC Aspire S IntraMail System Manual

Installation

Installing the IntraMail PCB

Installing the IntraMail PCB.
Step 1
- You should always wear a grounded wrist strap when installing or removing the IntraMail PCB.
- Be sure the wrist strap is attached to a known earth ground (such as the earth ground lug on the
- Discharge any built-up static electricity by touching the cabinet earth ground lug.
Step 2
- Included with the IntraMail PCB are four plastic stand-offs (spacers).
- You must install one stand-off in each corner of the IntraMail PCB.
- Be sure to install the stand-offs from the back (underneath) side of the PCB. Once installed, the
Step 3
Step 4
- Position the IntraMail PCB over the CN4 connector — then push the PCB into the connector on
- Push the corners of the IntraMail PCB down so the spacers lock into the CPU.
4 ◆ Chapter 1: Quick Setup
Take adequate anti-static precautions.
Aspire S cabinet).
Install the plastic stand-offs
IntraMail CompactFlash card must face up.
Insert the IntraMail CompactFlash card into the IntraMail PCB.
Insert the IntraMail PCB into the CN4 connector on the CPU.
the CPU.
CN1
CN4
Figure 4: Installing the IntraMail PCB
(Figure 4: Installing the IntraMail PCB)
IntraMail
CPU
.
Spacers
IntraMail for Aspire System Guide