NEC Express5800 Series Maintenance Manual page 124

Chapter 2 Useful Features
(3)
Consistency Check
The Consistency Check is used to check consistency among Virtual Drives (VDs). In "Ctrl-R", the operation can
be performed according to the following procedure.
Move a cursor to the Virtual Drive for which the Consistency Check is performed in the "VD Mgmt" screen, and
press the <F2> key.
The operation menu is displayed. Place a cursor on "Consistency Check", and press the <Enter> key.
The sub menu is displayed. Place a cursor on "Start", and press the <Enter> key to perform the Consistency
Check.
For the 1st Consistency Check after creating the Virtual Drive, the following warning message may be displayed.
To perform the Consistency Check, place a cursor on "Yes", and press the <Enter> key. At this time, a lot of
inconsistencies may be detected. However, it is not a problem.
The Consistency Check starts. Placing a cursor on the Virtual Drive for which the Consistency Check has started
displays the progress of the Consistency Check on the upper right of the screen.
124
Important

In the 1st Consistency Check after creating the Virtual Drive, the unused
areas may be inconsistent. Therefore, a lot of inconsistencies may be
detected and a warning log may be registered.

The scheduled operation of the Consistency Check cannot be performed
from "Ctrl-R".
Express5800/B120f Maintenance Guide
4. RAID System Configuration