Chapter 2 Useful Features
5.
Details of EXPRESSBUILDER
EXPRESSBUILDER helps you to install Windows and maintain the server.
EXPRESSBUILDER also provides bundled software and instruction manuals.
5.1
Starting EXPRESSBUILDER
You can run EXPRESSBUILDER by using the following ways.
Internal Flash Memory:
Remove a CD/DVD and removable media from the server, restart the server and press <F3> key at the
following POST message.
Press <F2> SETUP, <F3> Internal Flash Memory, <F4> ROM Utility, <F12> Network
When EXPRESSBUILDER starts from Internal Flash Memory, Boot Selection Menu shown in Chapter 2 (5.2
Menus of EXPRESSBUILDER) - (1) Boot Selection Menu will appear.
EXPRESSBUILDER DVD:
Use the DVD by the following two ways:
(1) Insert the DVD into the server, and then restart.
Boot Selection Menu shown in Chapter 2 (5.2 Menus of EXPRESSBUILDER) - (1) Boot Selection
Menu will appear.
(2) Insert the DVD into a computer running Windows.
Autorun Menu shown in Chapter 2 (5.2 Menus of EXPRESSBUILDER) - (4) Autorun Menu will appear.
Windows Application:
If EXPRESSBUILDER is installed to the server, you can run EXPRESSBUILDER as a Windows application.
Run NEC EXPRESSBUILDER from Windows Start Menu or run the shortcut on the desk top.
See Chapter 2 (5.2 Installing EXPRESSBUILDER) for details about the installation.
When EXPRESSBUILDER is launched as Windows application, Autorun Menu shown in Chapter 2 (5.2
Menus of EXPRESSBUILDER) - (4) Autorun Menu will appear.
168
Express5800/B120f Maintenance Guide
5. Details of EXPRESSBUILDER