NEC Express5800 Series Maintenance Manual page 143

Chapter 2 Useful Features
5. Set the capacity of the Virtual Drive to be created. By "Virtual Drive Size Unit", switch in capacity unit is
available. Set the capacity unit, and enter the Virtual Drive capacity in "Virtual Drive Size". You can set
the Virtual Drive name from "Virtual Drive Name" as needed.
6. Place a cursor on "Default Initialization" and press the <Enter> key to switch to [Fast] or [Full].
7. Place a cursor on "Save Configuration", and press the <Enter> key.
8. Select "Confirm" to change to "Enable", and press the <Enter> key.
Important
Use [GB] or [MB] for "Virtual Drive Size Unit".
Before executing "Save Configuration", ensure that [GB] or [MB] is displayed
for "Virtual Drive Size Unit"
5
6
Tips
The maximum capacity of the Virtual Drive is displayed as standard.
When [Fast] is selected in "Default Initialization", clear only the head sector where
the partition information is written. When selecting [Full], it takes time since
zero-write of all sectors is performed.
For parameters other than the capacity, use the standard setting without change of
setting is recommended. For details, refer to "4.2.3 (1) (b) CONFIGURE VIRTUAL
DRIVE PARAMETERS setting item.
Express5800/B120f Maintenance Guide
4. RAID System Configuration
143