Toro GreensPro 1240 Service Manual page 142

Motion Control Linkage (GreensPro 1240) (continued)
Chassis: Service and Repairs
The entire motion control linkage assembly must be secure and move freely
in both directions. Repair or replace the motion control linkage assembly
components as necessary
Use a suitable lifting device to safely raise and support the machine
to get access to the components under the chassis.
Each linkage rod includes 2 ball joints and 2 hex nuts. To allow adjustment,
1 ball joint and hex nut has left-hand threads, and 1 ball joint and hex nut
has right-hand threads. Before attempting to loosen the hex nuts for linkage
disassembly or adjustment, inspect the threads on the linkage rod to determine
the thread direction.
Note: Leave the linkage rod hex nuts loose until the rod ends have been secured
and the rod length is adjusted.
After assembly, check the transmission and motion control pedal return to neutral
operation and adjust as necessary; refer to
to Neutral Mechanism (page
(Figure 65).
CAUTION
Adjusting the Control Pedal Return
5–29).
Page 7–16 GreensPro ™ 1240/1260
14211SL Rev A