Servicing the Drive Roller (GreensPro 1260)
g273190
1.
Socket-head screw
2.
Lock washer
3.
Plain washer
4.
Hardened washer
5.
Brake hub
6.
Bolt (2 each)
Disassembling the Drive Roller (GreensPro 1260)
Assembling the Drive Roller (GreensPro 1260)
Chassis: Service and Repairs
GreensPro 1260
7.
Plain washer (4 each)
8.
Spacer (2 each)
9.
Locknut (2 each)
10.
Shim (as required)
11.
Set screw
12.
Bearing housing
Refer to
Figure 73
for this procedure.
1. Record the distance from the end of the drive roller to the bearing before
removal.
2. Loosen the set screw and remove the bearing assembly.
Refer to
Figure 73
for this procedure.
Note: It may be necessary to re-position the bearing during the drive roller
installation.
1. Position the bearing on the roller shaft in the location recorder during
disassembly and lightly tighten the bearing collar set screw.
Figure 73
13.
14.
15.
16.
Page 7–28
Drive roller
Motor and drive hub assembly
Plain washer (2 each)
Cap screw (2 each)
GreensPro
™
1240/1260
14211SL Rev A