Toro GreensPro 1240 Service Manual page 165

Steering Linkage (continued)
g273282
1. Steering pivot
2. Flat washer (8 each)
3. Ball joint (left-hand thread) (2 each) 7.
4. Hex nut (left-hand thread) (2 each)
GreensPro ™ 1240/1260
14211SL Rev A
GreensPro 1260
5. Steering pivot rod – short
6. Hex nut (right-hand thread) (2 each) 10.
Ball joint (right-hand thread) (2
each)
8. Steering pivot rod – long
The entire steering linkage assembly must be secure and move freely in both
directions. Repair or replace the steering linkage assembly components as
necessary (Figure 79 or
Use a suitable lifting device to safely raise and support the machine
to get access to the components under the chassis.
Each linkage rod includes 2 ball joints and 2 hex nuts. To allow adjustment, 1
ball joint and 1 hex nut has left-hand threads, and 1 ball joint and 1 hex nut
has right-hand threads. Before attempting to loosen the hex nuts for linkage
adjustment, inspect the threads on the linkage rod to determine the thread
Figure 80
11.
12.
Figure 80).
CAUTION
Page 7–39
9. Locknut (4 each)
Set screw
Woodruff key
Initial assembly lengths (before final
adjustment)
Chassis: Service and Repairs