Installing the Transmission (continued)
Hydraulic System: Service and Repairs
12. Secure the damper plate and linkage rod to the transmission control arm
(item 5 in
Figure
32) with the bolts, flat washers, spacers, and locknuts.
13. Secure the damper (item 3 in
washer and hex nut.
14. Remove the caps and plugs from the hydraulic hoses and fittings and connect
the hydraulic hoses to the fittings on the transmission assembly. Tighten the
hose swivel nuts to 32 N∙m (24 ft-lb).
15. Adjust the drive chain tension and lubricate the chain; refer to the Operator's
Manual. Dri-slide® multi-purpose lubricant (or an equivalent chain specific
lubricant) is recommended.
16. Fill the hydraulic tank with the correct quantity of new hydraulic fluid; refer to
the Operator's Manual.
17. Install the transmission cover to the machine; refer to
(page
7–58).
18. Raise the machine onto the transport wheels and purge the air from the
hydraulic system; refer to
19. Check the hydraulic fluid level and adjust if necessary. Check the
components for leaks and correct as necessary.
20. Check the transmission and motion control pedals return to the neutral
operation and adjust as necessary; refer to
Return to Neutral Mechanism (page
Figure
32) to the damper plate with the lock
Charging the Hydraulic System (page
5–29).
Page 5–48
Transmission Cover
5–42).
Adjusting the Control Pedal
GreensPro
14211SL Rev A
™
1240/1260