Servicing the Steering Rollers
g239521
1.
Roller tube (short)
2.
Roller shaft (short)
3.
Roller tube (long)
4.
Roller shaft (long)
Chassis: Service and Repairs
5.
Roller sleeve
6.
O-ring (2 each)
7.
Bearing (4 each)
8.
Flocked seal (4 each)
1. Remove the parts as necessary to repair the steering rollers. Discard the
flocked seals and O-rings.
2. Clean all the components before assembly.
3. If a bearing or bearing housing is removed, ensure that it is pressed into
position fully during installation.
4. Thread the roller shafts into the roller sleeve and tighten the roller shafts
to 92 to 124 N∙m (68 to 91 ft-lb).
5. Install new flocked seals and O-rings. Install the flocked seals with flocked
side of seal against the bearing.
6. Thread the locknuts onto the roller shafts and tighten the locknuts to 92 to
124 N∙m (68 to 91 ft-lb).
Figure 83
10.
Page 7–42
9.
Bearing spacer (2 each)
Locknut (2 each)
GreensPro
14211SL Rev A
™
1240/1260