Toro GreensPro 1240 Service Manual page 92

Removing the Transmission (continued)
Installing the Transmission
Hydraulic System: Service and Repairs
g241039
1. Hex nut
2. Spacer
3. Compression spring
4. Tension rod
5. Bolt
14. Remove the bolt, flat washers, and locknut that secure the idler arm to the
transmission mount, and remove the idler arm assembly.
15. Remove the retaining ring from the transmission output shaft.
16. Support the transmission and remove the bolts, flat washers, and locknuts
that secure the transmission to the chassis.
17. Slide the transmission away from the transmission mount until the sprocket
and drive chain are free of the transmission shaft, and remove the
transmission.
18. Remove the transmission drive collar and fan if necessary.
Refer to Figure 33 for this procedure.
1. If previously removed, apply anti-seize lubricant to the transmission input
shaft and position the fan, key, and transmission drive collar onto the input
shaft (Figure 35). Do not tighten the drive collar set screw at this time.
Figure 34
6. Flat washer (10 each)
7. Locknut (5 each)
8. Idler arm assembly
9. Spacer
10. Pivot bushing
Page 5–46
11. Retaining ring
12. Bolt (3 each)
13. Bolt
14. Locknut
15. Flat washer
GreensPro ™ 1240/1260
14211SL Rev A