Toro GreensPro 1240 Service Manual page 179

Removing the Transport Frame
GreensPro ™ 1240/1260
14211SL Rev A
The transport frame must be secure and move freely in both the raise and
lower directions. The latches must hold the transport frame securely in both the
raised and lowered positions. Repair or replace the transport frame components
as necessary.
With the exception of the transport frame itself, the transport frame components
can be removed for repair or replacement without removing the transport frame
from the chassis.
Refer to Figure 89 for this procedure.
1. Park machine on a clean, level surface with the transport wheels in the
raised but unlocked position. Shut off the engine. Engage the parking brake
if equipped, or remove the spark plug wire from the spark plug.
2. Remove the transmission cover from the machine; refer to
Transmission Cover (page
3. Disconnect the main wire harness at the following locations:
A. Hour meter harness
B. Interlock module (machine serial number above 315000000)
C. Seat switch (machine serial number above 315000000)
D. Parking brake switch (machine serial number above 315000000)
4. Disconnect the parking brake cable from the brake lever if equipped
90).
g240030
1. Parking brake lever
2. Parking brake cable
5. Remove the fasteners that secure the seat support to the chassis and rear
support frame, and remove the seat support from the machine with seat, seat
pan, manual tube, etc. attached
7–59).
Figure 90
GreensPro 1240
3. E-ring
(Figure 91).
Page 7–53
Removing the
(Figure
Chassis: Service and Repairs